emag acting funny

[knownothingmags]

was firing fine in emode.
then now when the magnet gets near the hes it just shuts the screen off and does not trip the sear.
the battery is fully charged.
the battery works great on my other emags.

for the emag that is not tripping the sear.
i have check my grounds they are great.
any ideas what might be going on here.

ive had this happen in the past and it was the ground but thats not whats going on here.

any ideas? solenoid bad? that seems weird if so. its hard wired and not a plug version so im not sure how to test if it is the solenoid.
lets dissect this.

thanks for the help.

** running 1.8

[vintage]

magnet polarity?

[knownothingmags]

Yeah tried that. I was thinking the same

Sent from my SM-G930V using Tapatalk

[Beemer]

Here ya go. Read this thread.

http://automags.org/forums/showthread.php?274739-Emag-issue&p=2912329#post2912329

[knownothingmags]

Here ya go. Read this thread.

http://automags.org/forums/showthread.php?274739-Emag-issue&p=2912329#post2912329Thanks Beemer I'll take a look

Sent from my SM-G930V using Tapatalk

[knownothingmags]

I did the paper wedge. Still the same eaxt thing turns the screen off no tripped sear.

I am now doing all of this with the trigger out of the fram starting away fro. The hes and moving slowly toward it.

Any other ideas?

Sent from my SM-G930V using Tapatalk

[Tunaman]

Remove the ground lug from the frame. Clean it good and clean the hole. Press it back in.

[knownothingmags]

Remove the ground lug from the frame. Clean it good and clean the hole. Press it back in.This one was tapped. So I ran tap through it to clean it and put the screw back in. Still same outcome.[emoji848]

***this just started happening too this wasnt an ongoing problem that i shelved.
Pulled it off the wall dropped a few drops of oil in the lines, and bam this issue showed itself.

Sent from my SM-G930V using Tapatalk

[knownothingmags]

figured it out the ground on the board screw was funny cleaned it up and tightened her down we are all good to go.
could have swore i had checked and done that already. good thing i checked again.