Ule feedneck removal

[trbo323]

Anything I need to know? I need to pull a stock feedneck off of a ule body, possibly away from my normal work station environment. I can bring a strap wrench, anything else I should Chuck in?

Sent from my Moto Z (2) using Tapatalk

[captian pinky]

Bring fire. Sometimes they are loctited in.


Sent from my iPhone using Tapatalk

[dstud2000]

If it is loctited in then fire or a heat gun, about 500 F is what you need.


Sent from my iPhone using Tapatalk

[trbo323]

Heat gun it is.

What do you guys use to grab it if I need to heat it up?

Sent from my Moto Z (2) using Tapatalk

[Sandman]

Commit to the fact you will not save the feedneck if it is Loctited on. Like Pinky says a little heat goes a long ways with loctite.
If you surrender to the fact of not saving the original..it's much easier to get off....:)
If there is no loctite you can remove it by hand and a nitrile rubber glove.

[captian pinky]

Screw a barrel in and use vise grips if needed if the heat gun doesn’t work.
Vise grips not pliers


Sent from my iPhone using Tapatalk

[trbo323]

If you surrender to the fact of not saving the original..it's much easier to get off....:)
.

Wellllllll .... Long story short I am trading bodies with someone locally. I have a clamping feedneck, he doesn't.

So either this works and I still have a clamping feedneck or it doesn't and......I don't have a feedneck

Sent from my Moto Z (2) using Tapatalk

[dstud2000]

Heat and patience


Sent from my iPhone using Tapatalk

[trbo323]

If I need a new feedneck, will this work?

https://www.ansgear.com/Custom_Products_CP_Angel_1_No_Rise_Clamping_Feed_N _p/cpangela1feednecknorisedblk.htm

Are "angel 1" threads the same as angel threads?

Sent from my Moto Z (2) using Tapatalk

[alpha_q_up23]

Strap wrench.

[Sandman]

Good question... They do designate it specifically as Angel 1 and others as WDP.
I don't know that answer myself.
Anyone know that answer?

Just my 2 cents. I would spend the extra money for Inceptions or Nummech. Not just because I sell them, but because they are both significantly stronger feednecks.
Empire feednecks are ultimately the strongest but they are the biggest too. They are less than Nummech and Inceptions but still more than CP.

[alpha_q_up23]

Those cp ones work, I use one on my pump below
https://i.imgur.com/ZlXoJvH.jpgh

Only issues I've come across was that there doesn't seem to be a lot of threads on the cp feedneck, idk if it is because I re-anodized the feedneck but I came across the issue where the feedneck loosened on me cause the weight of the hopper, luckily enough I caught it before any damage happened to the body/feedneck threads and I've since used Loctite on it and now it seems to hold strong, I can't say for sure for electronic hopper, cause I've only ever used a 100rd gravity fed hopper on it since

[alpha_q_up23]

And like Sandman says, spend a bit extra and get a more sturdy/beefier one, looking back on it, I would of probably chosen an inception feedneck for this build if they existed when I built it

[trbo323]

Needed the torch but I got it off.

Sent from my Moto Z (2) using Tapatalk