PDA

View Full Version : Intellifeed


SlipknotX556
03-10-2002, 08:37 PM
If i get a 12v revvy and hook it up with intellifeed will that be almost as good as a warp? cuz i really cant afford a warp right now.
nutz
03-10-2002, 08:46 PM
the only difference is that the revy will spin once every pull... it will be just a little bit faster than normal but no where near the performance of warp...

sorry to burst your bubble :)
SlipknotX556
03-10-2002, 08:55 PM
i knew it wont be as good as a warp but i am in finacil trouble and i can only afford the radio shack parts. so will that be a good choice to inellifeed my revvy?
nutz
03-10-2002, 08:57 PM
yea it would keep up with ur intelliframe for sure... yea it may chop a few times out of a case but it will be good...

i never chopped on my retro mag w/ intelliframe that i used to have and all i used was a normal 12v revvy :D
SlipknotX556
03-10-2002, 08:59 PM
why will it chop sometimes out of a case?
ThePatriot
03-10-2002, 09:03 PM
He means, in one case u might have a few chops, which everyone always does....
nutz
03-10-2002, 09:03 PM
just happens... almost always from shooting to fast... depends on situation too like how the gun is angled and if the paint is bad and stuff like that... the revy will most always keep up except when u get really pumped and start to rip on ur trigger with all ur energy into pulling it as fast as possible.. then it might chop
SlipknotX556
03-10-2002, 09:05 PM
i use big ball and sometimes those new sparkly marbs. But overall is the intellifeed good?
nutz
03-10-2002, 09:06 PM
yes u will be fine with it
SlipknotX556
03-10-2002, 09:07 PM
ok, thanks nutz for all the help.
DOWNWITHANGELS
03-10-2002, 09:46 PM
The Intelliframe cost $120. Thats not to far off. I on the other hand have the intelliframe already and I want to get the warp feed, mainly because I cant take these hopper shots anymore. Should I try to sell my Intelliframe and rev and maybe get a Z-grip??? I dont think the Intellifame will help that much when I got a warp feed.
SlipknotX556
03-10-2002, 09:52 PM
i already got an intelleframe.
Predater
03-10-2002, 09:57 PM
wire the warp to the intelliframe.
SlipknotX556
03-10-2002, 10:17 PM
like i said i dont got a warp. i cant afford one.
Predater
03-10-2002, 10:56 PM
sorry i was talking about what DOWNWITHANGELS said.

as for your deal the intellifeed just makes sure you dont have to worry about delay time with the electronic eye. i have and use intellifeed and it helps but wont compare to warp feed or the halo. them 2 things sorta force feed the balls. forcefeed isnt the right ward but i dont know a better one. did that help? :)
Jonno06
03-11-2002, 06:09 AM
now,someone has to tell him how to do it properly or he will blow something up(not like blowing up stuff isnt cool or anything)