lloyd_kinky
03-17-2002, 05:12 PM
My warp is running off of one 9 volt and is on vibration activation(not intellifed). It feeds when i fire and everything, but it doesn't slip by and do the 1/4 spin thing. It just stalls. Should I loosen the 2 bolts that hold the drive wheel and slip disks together? Do my batteries suck? I have gone through several fresh ones trying to get it to slip after feeding.
Also, could I used more voltage with out worrying about frying the board? Would 2 9's regulated to 12V work> What about the 10.8V NiMH battery I read about somewhere else on the site.
Any insight would probably help. Thanks
Also, could I used more voltage with out worrying about frying the board? Would 2 9's regulated to 12V work> What about the 10.8V NiMH battery I read about somewhere else on the site.
Any insight would probably help. Thanks