piranha pro ts g3 trigger job?

[Jonno06]

ok,i was wondering if there is anyway to shorten the pull of my piranha pro ts g3 trigger frame(not elcd frame one)....if anyone knows a way to shorten it somehow,please tell me,thanx

[Jonno06]

up

[jah871]

i would also liek to know how, however i need to know how to do it on a pirahna sts not a pro. thanks

[p8ntballa]

You cant shorten it but you can take the play out if it. Put some shims on the side of the trigger to take out the side to side play. And for the play after it fires you can take a small dowel and put it inside the spring...Cut it, check it, then sand it some, check it and repeat until you get it right. Same for all prianhas/spyders/.../.../.../....except elcds