View Full Version : Z-grip and foregrip extender question.
Newbie505
03-22-2002, 07:53 PM
I just bought a used z-grip from someone and when I went to put the foregrip extender on it it wouldn't fit. The trigger guard gets in the way. Is there a trick to this, or will I need to grind the extender down to fit.
You will need to cut a groove into the extender to make it fit properly. Someone on here has pictures of it, do a search.
Autotrigger
03-23-2002, 09:15 AM
You will need to spend a little time with a good file to make the rail extender work, bit it is worth it! See pic
Newbie505
03-23-2002, 11:26 AM
Thanks for everyone's help. I did a search like someone suggested and found out what I needed. I didn't have a small enough file, or bench grinder to use so I improvised. I measured it off and used a hack saw to define the limits of what I wanted to remove and then applied some careful manipulation with a rotozip. It's not the prettiest set-up, but it is serviceable. Thanks again for everyone's input.
C:\My Documents\mag z grip1.jpg
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.