PDA

View Full Version : Level 6 mag question..


boarderguy
03-24-2002, 01:21 PM
I have an older mag... Level 6 to be exact.. but i was wondering if its possible to use a spacer kit in an older mag?
boarderguy
03-24-2002, 01:32 PM
up
Army
03-24-2002, 02:04 PM
Yes, the internal dimensions did not change between levels, so a spacer kit will benefit your gun.

Level 6 guns had springs instead of spacers, but the spring was not adjustable enough, hence the spacers are part of the upgrade to level 7.
boarderguy
03-24-2002, 02:14 PM
ok well where do the spacers go? i ordered a set from AGD yesterday but i dunno where they go.. i just heard they were a very good upgrade..
Omicron
03-24-2002, 03:49 PM
check out this diagram:

http://store.airgun.com/acb/showdetl.cfm?&DID=17&Product_ID=153&CATID=6

Take off your bolt from the valve, and unscrew the powertube tip (brass) then in there, there will be a spring. Replace the spring with the powertube spacer. You might have to experiment, some spacers have leaking down the barrel or bolt stick.
PyRo
03-24-2002, 08:39 PM
Are you sure that it is a level 6? There arn't many left out there.
boarderguy
03-24-2002, 09:48 PM
yeah i'm pretty sure it's a level 6... the serial is
CF 02714 so its a nice OLD one but works flawlessly...
BlackVCG
03-25-2002, 01:33 AM
Do you have a yellow bumper on your valve? If so, you'll never find a spacer short enough to fit that gun.
Butterfingers
03-25-2002, 03:30 AM
I belive colored proteam spacers come in .195, 200, and 210 varieties if that is short enough.
FordPrefect
03-25-2002, 11:18 AM
Hey, are all MiniMags level 7? I have a spring instead of a spacer. Serial MM6858.
mykroft
03-25-2002, 12:34 PM
27xx is probably a Level 7. I've seen springs before in Level 7's. Heck, My ReTroValve had a spring in it when I got it (Second hand). The change from spring to spacer happened after the Level 6 - Level 7 change.
banzaimf
03-25-2002, 03:27 PM
Originally posted by mykroft
27xx is probably a Level 7. I've seen springs before in Level 7's. Heck, My ReTroValve had a spring in it when I got it (Second hand). The change from spring to spacer happened after the Level 6 - Level 7 change.

Minimag 1321 is a level 7.

as far as spacers go. They were a PTP aftermarket product from 93 or 94 till after I went into my hiatus in 1997, when I came out of my hiatus in 2000 the spacers were being put into mags.

banzaimf
BlackVCG
03-25-2002, 04:29 PM
All Minimags are Level 7. Some came with springs, others with spacers.

The main change from Level 6 to 7 is the removable PT was welded on for all Level 7 guns.
jewie27
03-27-2002, 10:37 PM
All Minimags are built to Level 7. Also look at your bolt, if it has a step in it, it's a Level 7 Mag.


My gun :Minimag w/Intelliframe and ReTro Valve