~WarpedRT~
03-24-2002, 04:34 PM
Today, my Warp did something it never did before. It refused to work. The vibration sensor will no longer let it run. So when I fire, it does not work. Only when I press the primer switch on the bottom will it run. Do I need a new board? What the hack is going on?
EDIT:
I think I may have found out whats wrong. I lost those two tine springs when I installed my intellifeed. That could be causing this, but I dont know where they go, and can anything else be substituted?
EDIT:
I think I may have found out whats wrong. I lost those two tine springs when I installed my intellifeed. That could be causing this, but I dont know where they go, and can anything else be substituted?