PDA

View Full Version : ProTeam 12V warp mod


Drizit
04-05-2002, 06:19 PM
I picked up the ProTeam 12v warp mod at skyball, i havn't used it yet but i'm about to. however i have it third hand that there may be some problems with it burning out warps, and in particular PTP warps. does anyone else know first hand about this??
BTAutoMag
04-05-2002, 07:45 PM
i dont know anything about this but if you could provide a link or two that would be nice.
56kSomeGuy
04-05-2002, 09:18 PM
What does the ProTeam 12v warp mod do? And how can i do it to my proteam warp feed?
orderofreason
04-05-2002, 10:11 PM
for instructions on how to make a 12v warp mod go to www.robagd.com however PTP makes a prefab one.
WickeDKlowN
04-06-2002, 02:33 PM
check out http://proteamdirect.com/ they sell em there, but i have never used one.
Drizit
04-09-2002, 04:03 PM
i have one, that's not the problem. the problem is i've been told they burn out the boards. also on another note, the clips that they use are junk, i put my finger nail through one when i tried to remove that battery.
Havoc_online
04-09-2002, 07:16 PM
I don't think 12v's is a problem, I my warp has 12v running it with no problems for a while now. I think more than 12v would fry it good though...
BTAutoMag
04-09-2002, 07:23 PM
if i were you id do the mod anyways i mean what happens if you accually do throw out your warp board. your screwed.
Drizit
04-12-2002, 04:34 PM
well i'll have to resodder that bloddy clip now before i can do anyting. thanks all
jurassic
04-12-2002, 08:19 PM
Warp 12 volt mods work great and are fairly simple!!

http://pettypb.com/timiwarp.html