Linking your warp and 9v revvy (electronicly)

[BTAutoMag]

I linked my warp and revvy together so that whenever my warp spins my revvy spins with it. so essentially i have them both ran with a vibration sensor.

-when my warp spins my 9v revvy spins.

-i run them both off of one 9v battery controlled by a on/off switch.

-there is a back up battery that i can switch over to with the flik of a switch if one battery fails.

here is the crappy pic of how i did it.

[Predater]

i have a 18v revy but i understood it fine. good idea. i may do that with my warp when i get it. got to sell my old mag first.

[BTAutoMag]

where did you get an 18 volt revvy i thought they only went up to 12... any ways im not sure about anything over 9 because of the max woltage issue with the warp board.

[hitech]

Originally posted by BTAutoMag
I linked my warp and revvy together so that whenever my warp spins my revvy spins with it. so essentially i have them both ran with a vibration sensor.

The circuit board in the warp doesn't have any problem with the extra current? I assume it doesn't since you said it works. Have you played a days worth of games, or just tried it out? I'm curious as it's simpler than my idea of using an SCR. :D