Intellifeed problem, Revy goes nuts when I plug the jacks together!

[MikeCouves]

Okay, I got my Revy and Intellifrane all successfully connected, but when I plug the jacks, this is exactly what happens.

The speed of the paddles speeds up.

The Revy will not stop spinning. Even when I put my finger in the eye the revy doesn't stop.

I don't know what to do, me and my dad have been stumped by a little bit of wires and metal :(.

Help me out guys I want it to work!

[a_malfunction]

Sounds like you have the switch mounted too close to the trigger rod. I set up the intellifeed on my brother's mag and it did that when I first set it up. Just loosen the screws holding the switch to the frame and push it back a little bit. Then re-tighten them and test it. Repeat if necessary.

[MikeCouves]

Okay let me try that out. I'll be back in a minute, stick around!

[a_malfunction]

Will do!

[MikeCouves]

Well that wasn't the problem. The problem was in the female end of the jack. The connections were always together causing it to always spin, my dad was using a little meter thing to see where connections were and stuff, and I didn't know what he was doing, but a little tape and bending got it all to work!

Woohoo I got Intellifeed. Sweeeeet.

Thanks alot anyways!