View Full Version : Does AGD make a longer on/off pin for RT valve?
thecavemankevin
04-08-2002, 06:21 PM
I have a RT valve and tried hooking it up to my hyper frame and the pin isn't quite long enough to reset the servo each fire. So i tried a slightly long Centerflag version and the diameter isn't quite wide enough to fill in the AGD on/off assy.
Any advice?
Well, I don't think it makes much of a differance with electo frames what your on-off leangth is. But yes, they do.
Butterfingers
04-08-2002, 06:59 PM
Thats actually not the problem.
The on/off pin of any length actally can extend further than the sear allows. The the sear stops the pin from further movement, not the pin itself.
The centerflag on/off pin is slightly smaller in diameter making for a lighter pull and less stress on the solnoids.
You have to twist open the two halves of the on/off assy and replace the stock o ring with the smaller centerflag o-ring. Yes the brass peice twists apart.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.