PDA

View Full Version : Micro Emag ?


56kSomeGuy
04-19-2002, 01:37 PM
Just wanted to know since the micro emag uses the retro valve. Could you use that retro valve on a regular mag? Also could you put the classic valve in the micro emag and make it work? Just wanted to know if this is possible cause i might be getting a used micro emag and wanted to know if i could fool around with the interchangable parts. I could make a classic micro emag and make the emag run on co2 YAY!:D (just wanted to know if it would work)
PsychoMag
04-19-2002, 01:42 PM
it will "technically" work, but at high ROF, you will probably experience a heck of alot of shootdown
FordPrefect
04-19-2002, 03:05 PM
Yea, it'll work. I forget who, but somebody did that. You will probably get liquid Co2 in the valve if you shoot really fast, though.
banzaimf
04-19-2002, 04:04 PM
they fit. I had to try it for S and G's. I laughed maniacally afterwards.

banzaimf
56kSomeGuy
04-19-2002, 04:31 PM
Also another question: how many bps can the classice valve achieve without freezing up?
banzaimf
04-19-2002, 04:35 PM
depends on your setup and temperature. I ran remote into an expansion chamber. seemed to work fine at extended high rates of fire. (1000 in about 5 minutes)

I would say though, that for most applications, you are going to see about 9bps.

banzaimf