PDA

View Full Version : Warp Feed Broken! aahh



FeelTheRT
04-27-2002, 11:09 PM
Well its not mine but its a friend of mine and he hates it because its broken and he says if i find out that if AGD will fix it for free he will get it fixed and sell it to me so here goes...

He says the Warp will keep spinning no matter what. He's turned the vibration senser up and down up and down and it does no good, no doubt its a problem with the electronics... but will AGD fix it for whatever to make it work for free...?

BlackVCG
04-28-2002, 12:44 AM
Is he running it off of just one 9V? Try pulling the bottom jumper off the block of three jumpers on the right of the board. It might have a bad board. Call AGD and see what they can do for you.