Cypres0099
04-28-2002, 10:11 PM
Yes, the first day out with my Emag. I have been staring at it and pulling the trigger for almost a week now.
Teflon H/R
Warp
14 in Freak
Stupid 47 ci crossfire... (I need to find a Flatline)
12v Rev
Sadly I only had 750 rnds.:( If you own an Emag and use hybrid mode you know what I mean about that.
All I can say is, if Speedy Gonzalez had a paintball gun, this would be it.:p The hybrid mode is amazing. 2 minutes into the game I look down, no more paint in my hopper... Fill'er up.:) There were a couple times that I forgot to turn on one of the 5 things on my gun.:p
There were a couple things today that concerned my though, one of which was not the Emag's fault.
1. I had probably 4 breaks down the barrel one of which I couldn't tell if it was a chop or a break. I know what to do about the breaking, which may have been partly because I changed paint and didn't bother to change the insert, later I found out that it was a little loose. For the breaking I need to sand the bolt.
2. This is with my warp. I noticed that my batteries after about 500 rounds would not power the wheel enough which may have caused a chop although I'm not sure if it was a chop or a break. My question is, could large gauge wire take away some of the batterie's juice? I installed an on/off switch and used semi wide wire I don't remember how wide off the top of my head but could that be a problem.
I have always had a problem with the warp batts. Even with ultras and E2. I just ordered some NiMH. Hopefully that will help.
I love my Emag sooooo much. After I sand the bolt it will be soooo good. I just hope that my warp quits acting up.
Teflon H/R
Warp
14 in Freak
Stupid 47 ci crossfire... (I need to find a Flatline)
12v Rev
Sadly I only had 750 rnds.:( If you own an Emag and use hybrid mode you know what I mean about that.
All I can say is, if Speedy Gonzalez had a paintball gun, this would be it.:p The hybrid mode is amazing. 2 minutes into the game I look down, no more paint in my hopper... Fill'er up.:) There were a couple times that I forgot to turn on one of the 5 things on my gun.:p
There were a couple things today that concerned my though, one of which was not the Emag's fault.
1. I had probably 4 breaks down the barrel one of which I couldn't tell if it was a chop or a break. I know what to do about the breaking, which may have been partly because I changed paint and didn't bother to change the insert, later I found out that it was a little loose. For the breaking I need to sand the bolt.
2. This is with my warp. I noticed that my batteries after about 500 rounds would not power the wheel enough which may have caused a chop although I'm not sure if it was a chop or a break. My question is, could large gauge wire take away some of the batterie's juice? I installed an on/off switch and used semi wide wire I don't remember how wide off the top of my head but could that be a problem.
I have always had a problem with the warp batts. Even with ultras and E2. I just ordered some NiMH. Hopefully that will help.
I love my Emag sooooo much. After I sand the bolt it will be soooo good. I just hope that my warp quits acting up.