View Full Version : RT foregrip extender on Micromag?
muirtach
06-03-2002, 04:14 PM
I noticed that there are some used RT foregrip extenders in the store and was wondering if anyone knew whether they would fit on my micromag without too much work, drilling, tapping etc.
AssassN
06-03-2002, 05:28 PM
They use 3 screws on either side so would probably have to make screw holes in your rail. I am not a machinest so u might have luck with someone else. My bet is that it would take mad work.
Creative Mayhem
06-03-2002, 05:32 PM
dude, buy a Kapp extender. `nuff said
muirtach
06-03-2002, 05:36 PM
Kapp's don't fit right on micromags
FordPrefect
06-03-2002, 09:44 PM
Why don't they fit right? I didn't know that.
muirtach
06-03-2002, 09:55 PM
they use an alternate attachment design for the verticle adapter, it's trapeziodal not flat to the body. It is possible from what I hear to mill, or file, an angle out of thh actual foregrip extender. I'm looking for an easy answer so that doesn't quite work for me though.
Sorry to open this up again but i have a similar question. I have an AM classic and was wanting to use the rt foregrip because it looks hella cool. Can you buy an rt body rail, or will you have to chang the body also?
Thanx,
Loki
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.