View Full Version : VL Revy question
whats the best way to clean my revy w/o damaging the electrical components?
MrMag
06-12-2002, 09:47 PM
it is actually quite simple to just unscrew everything. on the intelliframe instruction page, it shows u the precise way to do it
Are you chunking balls inside your Revvy? If so, you've got bigger problems. If you've got a lot of paint inside, then you definitely need to take it apart. Otherwise, you should just be able to stick a lightly damp cloth inside and twist it around. Then use a dry cloth to clean up any residual moisture. You should be good to go after that.
:D
Schnitzel
06-13-2002, 09:19 AM
remove all the screws, lift out the board, servo, and sensor. rinse the two shells under a faucet. JUST MAKE SURE YOU DONT GET ANY OF THE ELECTRICAL COMPONENTS WET!
street1356
06-13-2002, 05:28 PM
you can just squirt water into it and then dry it out
just as long as u dont get too much water in it
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.