mrhooie
06-27-2002, 09:58 AM
Hey guys - quick question
I just got a new stem and fitting for my HPA fill station, to be able to use a larger output n2 welding tank
I was using XPR n2 welding tanks (output pressure starts at about 6000psi)
The only shop in town is out of them.
Anyone ever used compressed air welding tanks? I haven't checked the fitting but its probably a cga680(which is my new stem and fitting) - but I'm curious to see if this will do the trick
Thanks as always
I just got a new stem and fitting for my HPA fill station, to be able to use a larger output n2 welding tank
I was using XPR n2 welding tanks (output pressure starts at about 6000psi)
The only shop in town is out of them.
Anyone ever used compressed air welding tanks? I haven't checked the fitting but its probably a cga680(which is my new stem and fitting) - but I'm curious to see if this will do the trick
Thanks as always