View Full Version : Turning the standard feed into center feed
benji331
07-07-2002, 02:44 AM
Has anyone done this before? I was looking at my standard body and noticed all i had to do was rotate it and transfer the holes and the slot to make it a center feed. I have got all the holes drilled and am cutting out the slot. I am not shure on how to reattach the grip frame screw nut back onto the body. I can do any kind of welding, brazing, etc., but was wondering if something like JB Weld would also work. Any ideas?
RTGuy86
07-07-2002, 03:16 PM
ballistics sports did it. it looked pretty good to.
benji331
07-07-2002, 09:28 PM
Do you know how they did it? Using a drill, metal mill, dremel tool, etc.?
RTGuy86
07-08-2002, 12:24 AM
i wasnt there when they did it. i say when it came in and when it left.
rjvemt1
07-09-2002, 09:26 PM
what are you gonna do about the old holes and slot that will now be letting all sorts of crap get into the gun? why not spend 100-120$ and get a new centerfeed body from the store? then once you get the centerfeed barrel you could switch back and forth if you felt like it.
benji331
07-10-2002, 09:12 PM
Duck tape my friend, duck tape. The old holes are half way covered by the body rail, so i just got to keep it out of the dirt.
subbeh
07-10-2002, 09:55 PM
Ahh. A true hack-job!
Tunaman
07-10-2002, 10:18 PM
Forget the JB Weld. Have it Brazed back on...it the only way it will ever hold
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.