subbeh
07-09-2002, 08:36 PM
I was hoping someone could help me out. I have searched and found much, but nothing that has helped.
I am trying to fix my friends 68 automag valve. Before I begin, I've already replaced everything in a parts kit and the whole on/off assembly. Often times when the trigger is pulled it will slowly start to leak (couple seconds) then just burst will full air, until the trigger is pulled down. Sometimes it will stutter or double or even tripple shoot. Whenever it does shoot, it has extremely low velocity (though the velocity may be set low, I'm not sure).
This is a bit of an older valve, I believe, simply because the on/off that was in it was the older version.
Please, any recommendations I will do.
I have tried power tube spacer kit. It gets better the lower I go. I have even grouned the lowest one lower and lower trying it every time and it still will not correct the error.
ANY suggestions welcomed, I'll try anything.
Questions? Let me know and I'll answer them. Thanks much for your help, guys.
I am trying to fix my friends 68 automag valve. Before I begin, I've already replaced everything in a parts kit and the whole on/off assembly. Often times when the trigger is pulled it will slowly start to leak (couple seconds) then just burst will full air, until the trigger is pulled down. Sometimes it will stutter or double or even tripple shoot. Whenever it does shoot, it has extremely low velocity (though the velocity may be set low, I'm not sure).
This is a bit of an older valve, I believe, simply because the on/off that was in it was the older version.
Please, any recommendations I will do.
I have tried power tube spacer kit. It gets better the lower I go. I have even grouned the lowest one lower and lower trying it every time and it still will not correct the error.
ANY suggestions welcomed, I'll try anything.
Questions? Let me know and I'll answer them. Thanks much for your help, guys.