View Full Version : Level 10 beta. Need help from people who have theirs together.
clanger
07-09-2002, 10:27 PM
I'm new to this bolt break down and I'm having trouble getting it up and running. My current problem is that I get a leak from the back of the valve where you put the wrench in to adjust velocity. Any clues on what I'm doing wrong?
Thanks
Chris
TransMan
07-09-2002, 10:41 PM
you have the reg screwed in too far if u have to have it in that far to shoot then you need to go one spring size smaller ,break in the spring your usin, or use a bigger carrier
virus
07-09-2002, 10:45 PM
that venting means you have the velocity set to high....
goto the LV10 info thread and make sure everything is setup right....
i'm thinkin off-hand (and on very little sleep) you need to:
turn the velocity down so teh leak stops and go another 1/2 turn
if it still wont fire right/at all switch to the next smaller spring in the kit...
that should clear it up also if possible put it over a chrony to dial it right in....
VBmag87
07-09-2002, 10:48 PM
^i am with him, your velocity is too high with the current spring you have so go to the next size smaller. Or try the other things Trans said.
clanger
07-09-2002, 10:48 PM
Okay, I turned it down and it stopped leaking, on to adding shims now, thanks guys! I appreciate you guys helping me out.
Chris
TransMan
07-09-2002, 10:50 PM
NO prob
clanger
07-13-2002, 01:17 PM
I went to my paintball field today and still had problems getting level 10 working flawlessly. My problem is that I can't get it to fire without it leaking out of the back still. I slowed down the velocity on the middle bolt to were it wouldn't leak but it fires at 200fps. I switched to the smallest spring and when I fire at 280fps it leaks out the back still. I don't know what I should be doing or what I'm doing wrong but if you guys could offer me some more help or tips that would be great. Heres my setup so far:
Retro Mag
1.5 Carrier
2 shims
Smallest spring
Thanks
Chris
athomas
07-13-2002, 04:08 PM
How old is your mag? Your spring pack may be worn out and weakened. You may need to get a new spring pack.
clanger
07-13-2002, 04:10 PM
My mag is all upgraded, and I'm using the smallest spring agd sent me in the lvl 10 kit.
Brian68mag
07-13-2002, 07:12 PM
might want to try to replace this
http://store.airgun.com/acb/showdetl.cfm?&DID=17&Product_ID=48&CATID=6
good luck
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.