automag trigger

[Berzerk]

I bought an automag a few weeks ago and have shot about 1000-1200 paintballs with it. It was working fine until yesterday when I shot about 400 paintball through it. A few times when i pulled the trigger it would fire one paintball when i pulled the trigger and another when i released the trigger.

[Wc Keep]

did you buy it used? because if you did it might have a response trigger on it.

[SyntaxError]

oddly enough it sounds like your sear is too short or something...

[TheTramp]

Take apart your power tube and on/off. Make sure the o-rings look good. Clean and re-oil every thing and put it back together. Try it out and you should be ok.

Just a hint: If you post this in the Tech forum you'll probably get a better response.

[athomas]

Check for a damaged on/off pin, or a worn sear assembly. An on/off pin that is too short will have the effect of shooting on the pull and release of the trigger. Maybe the on/off pin got damaged on the end when you removed the valve the last time you had it out.

Anyway, check it and let us know. We'll try to help you out.

[potti]

check your sear and base of your bolt for wear. the sear could be slipping.