Having some trouble

[FreshmanBob]

So I won an intelliframe from AO day yesterday and put it in just now. After gasing up the gun, it won't fire. The trigger rod is pushing the trigger back, but when i pull the trigger the gun doesn't fire, there's just pressure from the on/off. It's like the sear isn't dropping on the bolt or the bolt won't fire. So far i've tried increasing the velocity and input pressure. My next guess is to try a lighter main spring or smaller level 10 carrier.

Can anyone give me some advice?

[FreshmanBob]

nevermind guys, it was the trigger rod. Aparently the benchmark frames tolerances were either bad or just too different from the stock agd's and intelliframes. I had to shorten the trigger rod by about 1 an 1/3 turns and its back to normal.

This intelliframes sweet, it's so short it will take time to get used to it.


Now to radioshack!