PDA

View Full Version : upgraded to hpa mag acting funny


rfelker
07-23-2002, 03:25 PM
Just bought a crossfire 68 3000. Tried it on my mag and noticed that its hard to screw on the asa. And when its gassed up trigger pull feels heavy. I did swap out all orings and bolt spring with new one. Could this be it? Also seems like when I shoot theres no power. When I was running co2 I had great range. I checked the new spring and its alot longer than old one. Just wondering if I should swap it back. And 1 last thing, is it 1.99 inches or mms for rod length? And how Im I supposed to measure it? all I have is a measuring tape. By the way everything on gun is stock.
mykroft
07-23-2002, 04:22 PM
1.98" from the tip to the pin in the clevis.

You bought a preset with the HP output right? the LP Crossfires (450 or 540psi) will get shootdown on a mag.
rfelker
07-23-2002, 05:08 PM
its a crossfire fiber so it should be a 850.
krafty
07-23-2002, 05:29 PM
What color is your reg? Red ones are 800/850 psi, Blue ones are 450 psi output.
rfelker
07-23-2002, 05:40 PM
Its all silver
covadsucks
07-24-2002, 10:28 AM
Is it just a stiff trigger pull or does the gun see a lot of shootdown?
athomas
07-24-2002, 12:12 PM
Originally posted by rfelker
I checked the new spring and its alot longer than old one. Just wondering if I should swap it back.

Keep the new spring. The old one was probably worn out if it is a lot shorter than the new one.

Make sure you put plenty of lubricant on the o-rings when you first replace them.