emag won't fire in manual

[dropkick1]

like the topic says, my emag won't fire in manual. it fires in electric and hybrid, but won't fire in manual.
i just installed level 10 and it works fine but it just recently started not firing in manual.

ken

[dropkick1]

up

[athomas]

Try removing a shim.

You may be operating too close to the point where the gun won't fire if a slight obstruction exists or if some of the gas escapes out the bolt. When you pull the trigger in manual mode, the bolt may be shifting slightly causing the pressure in the chamber to change due to some gas escaping. This wouldn't happen in when you fire electronically because the sear pull is much quicker than your manual pull.

[dropkick1]

tried that but nothing, we're experimenting with different sized carriers etc, but i could use some more advice.

ken

[athomas]

Have tried turning up the velocity just to see if it will work at a higher front chamber pressure?

[dropkick1]

so far it wasn't the carriers, haven't had time to play with it much but i may try a weaker spring and try turning up the velocity.

ken

[HyperSnyper]

That could be a shot that the pin could be a little too short to trip the sear.


I fired the gun many times in M mode on my Micro E when I got it in, loved the feel... That was until the battery finished charging. Pure E all the way! Why would you ever want Manual?

-Hyper

[dropkick1]

just in case anything would happen and b/c its fun

ken

[dropkick1]

up, how do u adjust the trigger pin length, any help would be appreciated, i'm starting to get annoyed with it. i tried turning up the velocity and did so till it vented but nothing, please help.

ken