View Full Version : Level 10 and the E-micro
askearl
08-02-2002, 03:24 PM
Well for all of you that are interested. I have just finished fine tuning a level 10 in an e-micro for a customer and it is working great. The biggest change I made was changing the length of the on/off pin. I don't know if this is going to be required in all guns but it was in this particular one. I had to increase the length to .688. I am getting ready to install the next one in a couple of minutes. If you have an e-micro with a level 10 please give me some feedback so I don't have to reinvent the wheel. At the same time, as I narrow down the problems I will continue to post.
The mag is re-born!:D :D :D
emag2002
08-06-2002, 05:27 PM
i have a micro emag i put a lvl 10 kit in it worked great ,,i didn't have to do any thing to the on/off pin after a few hundred shot went to a smaller carrier ,,used it this wkend fired around 600-800 shots worked great no problem at all
dropkick1
08-06-2002, 06:46 PM
i put mine in a weeka go and it works fine in electro and hybrid, but doesn't work in manual. how and where do u adjust the on/off pin? or any tips ingeneral on how to put it on my micro-E.
ken
askearl
08-07-2002, 08:16 AM
Normally I hear just the opposite. What exactly is it doing (or not doing) in manual mode. If you want, give me a call at the shop, it might be easier.
dropkick1
08-07-2002, 02:34 PM
the trigger just pulls in but doesn't actuate the sear, i've tried a bunch of different set ups but i took it out last night and will start a new when i get a chance to.
ken
askearl
08-07-2002, 03:23 PM
Try lengthing the manual trigger rod some.
dropkick1
08-07-2002, 04:29 PM
ok, how do u do that?
ken
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.