View Full Version : NW Quick Disconnects ... need pins?
jeffremiller
08-05-2002, 06:13 PM
I have accumulated three complete NW disconnects over the past year or two. But I only have one pin.
Anyone know where I can get a pin for these. I checked local hardware and automotive store. No luck so far.
Thanks
J_
Bad_Knees
08-05-2002, 07:07 PM
Try www.mcmaster.com or any industrial hardware store. Ypou will be looking for a locking pin or a steel dowel (if you go the dowel route you'll need to drill a hole in one end for a pull ring.
bambam
08-06-2002, 12:26 PM
Try the The Home Depot. I get some parts there for paintball use... :D
FrAuStY
08-06-2002, 12:55 PM
I was in home depot yesterday looking for some screws for my wheels, and I saw one of these for about 1.50$ I know the home depot locally has them so most around the country should carry them. They are in the fasteners section (nuts,bolts, and screws)
BlackVCG
08-06-2002, 10:42 PM
Use a Cocker back-block pull pin.
jeffremiller
08-07-2002, 02:10 PM
I found them at an online boating store under sailing gear.
Called a detent pin.
Same thing as supplied with the NW QD's
J_
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.