automag pro -revolution

[livinglegend-g]

I am relatively new to the sport of paintball and i just purchased my automag pro. when i put on my 12v revy onto my center feed mag it isn't snug fitting at all. Is there some sort of adapter that i need to buy that will make it fit snug on my automag pro? I used to play with a spyder and it fit fine on that.

[Z-man]

Well there may be better solutions but a bit o tape is a nice cheap quick solution. My revy is a bit loose in my Warp so I just use a bit of tape. I have to change it once in a while but hey, it's very quick.

[xmetal2001]

There is a spacer you can buy(i think DYE makes one), but you can always just use tape.

[MagNewb]

How Would i use tape???

[xmetal2001]

Wrap it around the neck of the revy.

[Z-man]

right. Wrap it one layer thick around the neck of your revolution and if 1 layer is not enough, then go to 2 layers.

[PyRo]

I used electric tape, which is what everyone uses, but I had a problem with it slipping, and the hopper turning when it got a little wet. I solved this by using some friction tape stuff. Also, you can buy the adapters, a bunch of companies make then, they shouldn't be too expensive.