Problem with E-mag and Warp Feed Connect

[snakeman]

I am trying to hook my warpfeed to my E-mag. I hooked it up to the connector in the E-mag frame. After that I opened the warp feed and pulled the middle jumper and moved it to the location above it.I then put the batteries back in.

The warpfeed won't stop turning. Pressing of trigger has no effect.

I would like to see a picture of the jumper layout just to be sure what I have is correct. Is there a "hidden" reference somewhere? What jumpers are needed to be pulled or moved to hook the E-mag to Warpfeed?


Dirk

[Tunaman]

You do have the warp wire going to the middle connector in the grip right? Also, open the warp back up and turn the sensitivity Potentiometer a little.

[Havoc_online]

you pulled the wrong jumper bud. the bottom is vib., mid is pos., top is neg.

in other words, leave the mid, pull the bottom(so the only jumper is on the mid, nothing on top either)

hope this helps:)

[snakeman]

Well it was the jumpers. I did like you said Havoc_online and its WORKS! Great! :) Thanks Havoc_online.

Thanks again,

Dirk