View Full Version : Warp w/o an intelli
RexTheKing
09-14-2002, 01:12 PM
Has anyone actualy used a warpfeed without an intelli on a mag? does it work well?
joeyjoe367
09-14-2002, 01:24 PM
It'll work fine. You just use the vibration sensor instead of a direct cable link.
takes a bit of tuning, but couldn't take more than 5 minutes.
I used one at Shatnerball...
after turning the sensitivity WAY up I didn't have any problems at all with it. but if the sensor is not turned up... you'll be tapping the side of the warp quite a bit.
---Fred
Aranarth
09-15-2002, 04:00 PM
Works fine. Just got to turn the pot up a bit.
-AranarthX
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.