View Full Version : Intelli-Frame to Warp- Which Jumpers stay?
Ok, I read the manual on airgun to do this. It says the outter to jumpers need to be IN, leaving the middle one open. My Emag was the opposite. Middle jumper in, outter ones open. Is the desired affect of activation on every pull the same as the Emag, wouldn't it be the same jumper set up?
vf-xx
09-19-2002, 01:07 PM
No because it's a different signal. With an intelliframe the switch closes a circut. With the emag it sends a pulse. hence the difference.
Nice! That explains it. Thanks man.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.