dave_p
09-21-2002, 03:19 PM
i have a brass eagle revolution. its a 9 volt. i bought a 12 volt rev 4 blade prop and a 12v board for it for 20 bucks. the board is fried. so i wanted to put the prop to use and i figured i have extra battery clips now, ill make my 9 volt an 18 volt. battery life is not an issue cuz you wind up getting new batteries for a day of play anyway som im not concerned with the regulation down to 12 volts.
i removed the jumper from my 9 volt board and attached two of the battery clips from the dead board so now i have an 18volt revolution with 4 blade prop. it spins as fast or faster than a x board revvy now. my question is this.
does anyone know if the 9 volt revs suffered from the same 1ms delay the pre x-board/post brass eagle takeover 12volt revolutions do??.
im still getting the occasional dry shot.
i removed the jumper from my 9 volt board and attached two of the battery clips from the dead board so now i have an 18volt revolution with 4 blade prop. it spins as fast or faster than a x board revvy now. my question is this.
does anyone know if the 9 volt revs suffered from the same 1ms delay the pre x-board/post brass eagle takeover 12volt revolutions do??.
im still getting the occasional dry shot.