Load sm5

[persistent]

sorry to bother you but i am waiting on an extreme (preordered 2 months ago) and i have a dynaflow that i would to have a suggestion on input pressure from you, the thing is my guage only goes to 700 psi
also i am going to run the hose in a crescent moon shape to the inlet and would like a suggestion on hose length as well
i would appreciate anyones input on this and addressed to load because he uses or used a dynaflow

ps i tried a search

[Load SM5]

Hose length depends on your drop as well, but with a medium to long shocktech drop I ran a 12" hose with QD. With the mini drop I run a a 10 with a slidcheck Q/D. One thing you may want to consider as that certain drops, like the shocktech's, are a little too small for the built in rail of the Dynaflow and if put under stress the reg housing will crack. Go to Centerflag's site and see what mounts they recommend.

Input pressure was set around 750-800 but I use 900 with level 10. It seems to need a higher input on my SFL for some reason.

[kutter]

Load any idea why it seems to like the higher pressure? I run my SFL w/ lvl 10 on a preset and it does just dandy. But I always play in strictly E-mode, so I wonder of it would make much difference. Any ideas?

[Load SM5]

Well a preset usually runs at 850 which is about where I run mine now. Before lvl. 10 I ran it about 750 with no issues. After level 10 750 caused it to skip a shot every now and then like the tank was'nt keeping up. Just my experience most likely.

[wyn1370]

dynaflows are best run at 600psi (straight from the maintenance manual). no matter where you set the tank that is where it wants to run. I would suggest if different tank if possible.

[pito189]

Load you wouldn't happen to have any of those medium shocktechs you are looking to trade for a long one would you?:confused: :D

[Load SM5]

No I don't, sorry.