Need specs on a mag body! (TK or another AGD representative most likely needed)

[Skoad]

I'm working on a project and need the:

a) interior diameter (i think it's 1 inch on the dot)

b) wall thickness or total diameter

c) how far up in the tube is the ring to stop the bolt/spring (from the back because all fronts are different sizes)

d) the thickness and diameter of the hole in the spring/bolt stopper in the middle of the tube

e) how far up the body is the feed tube (again from the back and assume it's vert feed, please specify if your going from the center of the feed tube or the outer)


EXACT answers is what im looking for, or if you can get it close that will do too :) If anyone has some kind of drawing/chart with all these lengths n such it would help greatly.

Other helpful info would be, how much pressure must the spring/bolt stopper disk in the middle of the body withstand?


-Skoad :)

[Skoad]

up

[Hexis]

It's a common request, and it has been constantly ignored. Don't get your hopes up.

[Skoad]

someone said this was patented stuff and that they can't give it out to me, i could just measure it myself when i get home this weekend but was hoping to buy some stuff before then :)

[Damage]

Skoad if you do get the measurments would you please post them or PM them to me? I have posted the same question for different reasons. I have a custom body that wont fit level 10 and I wanted to hone the body to the correct size and I posted close to the same question in the tech section and it was almost completly ignored (Thanks to those that tried to help) I thank you for your time and effort.

[Potatoboy]

C: 3.5inches to the back of the retaining ring

[magmonkey]

ok heres the deal
If anyone from AGD doesn't want these up PLEASE delete it
I am not doing this to irritate them I am just answering a question

onto the measurements

I measured 4 bodies just to be sure

1 clasic feed

I.D. 1.008

O.D. 1.114 (.050 wall)

Depth to first step on spring stop 2.789

Depth to second step (where the spring actualy sits) 3.040

I.D. of spring retainer .697

1 minimag hopper right feed

I.D. 1.006

O.D. 1.111 (.050 wall)

Depth to first step on spring stop 2.789

Depth to second step (where the spring actualy sits) 3.043

I.D. of spring retainer .697

1 emag warp left feed

I.D. 1.010

O.D. 1.114 (.050 wall)

Depth to first step on spring stop 2.789

Depth to second step (where the spring actualy sits) 3.044

I.D. of spring retainer .697

1 emag center feed

I.D. 1.016

O.D. 1.111 (.050 wall)

Depth to first step on spring stop 2.789

Depth to second step (where the spring actualy sits) 3.036

I.D. of spring retainer .697

and because you asked for the center feed specificly

3.6815 to the center of the feed neck


All depths are taken from the back of the bodies


again if agd does not want these out please delete this post

if not and you have any other questions feel free to ask

[magmonkey]

up please