PDA

View Full Version : Warp Problems


Strider
10-31-2002, 02:11 PM
Hi all. Just picked up a used Warp, but I can't get it to do anything. :(

I attach a 9v, nothing. The battery is fine...

I checked the jumpers inside, I have one jumper on sensor, and I have four jumpers on the dwel. I've played with the blue knob, but I can't get anything to go.

Just a note, it currently has an interlink cable on it for an Angel. It didn't fit my Emag port, thats correct right?
hitech
10-31-2002, 02:59 PM
What happens if you press the prime (white) button? It should spin. If it doesn't there is something wrong with the warp. If it does, it's something else.
Strider
10-31-2002, 03:12 PM
Absolutly nothing happens.
wyn1370
10-31-2002, 03:37 PM
make sure all the wires are still sodered to the board. Being that the battery wires are not anchored, they have a tendency(at least in my case) to detach from the board.
Strider
10-31-2002, 08:33 PM
Bang on wyn. My positive wire is disconnected. Thanks!

Off to Temo Vryce's Soldering Iron! :D
Strider
10-31-2002, 10:49 PM
Well, all is good and whirring.

Long Live the Thunder Chicken Soldering Tech. :D