Ricochet and JMJ Vortex Impeller

[sneakyhacker420]

JMJ products made the votrex impeller for the viewloader revolutions, i have a ricochet AK loader, and i am wondering if one of these impellers would increase feed rate if i bought one and used it

are there any compadibility issues?

feed rate increase?

and any other facts


thank you

-sneaky :)

[spazzed]

Good question. If it'll fit, give it a shot. Can't hurt anything ;-)

[AzrealDarkmoonZ]

The angles are wrong, I put the impeller on a Ricochet and it was horrible, sometimes it would appear to feed correctly but I noticed at a certain point it would throw the balls away from the feed hole.

Matt D

[sneakyhacker420]

so the stock impeller is better?

now i am thinking of drilling 2 more holes in the impeller pole thing and putting 2 more weed-wacker lines w/ rubber ends into it.. do you think that it would work better then?

[TheJester]

i don't think it would i have the 2k, and i've made some personal mods to it too such as a vibrating reload alarm, but if you put more "blades" in there i think the timing would be off, and the extra "blades" would end up blocking hte feed port, cause i don't know about yours, but mine are positioned that the blades are never over the feed port blocking it, but hey, if you can get it so it won't block it, hell do it up