DocRocker
11-23-2002, 10:58 PM
Hey I havent found any similar problems as this one.
First: I have an EMAG with the LX installed. Using the largest carrier possible without any leaks (1.5 I think) 2 shims and the cut spring. It shoots fine but there is this strange quirk that I cant seem to fix and I cant tell if its from installing the LX or not.
The problem:
when I gas the gun up it shoots fine. however if the gun sits for about 3 minutes or longer it wont shoot on the first and sometimes second trigger pull. In emode you can hear the solenoid click with each trigger pull but it'll only shoot after one or two pulls. If I let the gun sit and try to shoot it in manual mode it wont shoot either on the first pull. The trigger goes all the way back and pushes the sear rod all the way back too!! Very weird situation. It seams as though the sear assembly is sticking or the on/off pin is not being pushed all the way out when it resets
What I've done: I've inspected and oiled all the orings. None of them seem to be worn at all. I took out the sear to make sure the solenoid wasnt bent and causing some friction. Everything seems to be in line.
This is a pain b/c I always have to pull the trigger a few times to make sure it will fire before I snap shoot or something
please any suggestions would be great
First: I have an EMAG with the LX installed. Using the largest carrier possible without any leaks (1.5 I think) 2 shims and the cut spring. It shoots fine but there is this strange quirk that I cant seem to fix and I cant tell if its from installing the LX or not.
The problem:
when I gas the gun up it shoots fine. however if the gun sits for about 3 minutes or longer it wont shoot on the first and sometimes second trigger pull. In emode you can hear the solenoid click with each trigger pull but it'll only shoot after one or two pulls. If I let the gun sit and try to shoot it in manual mode it wont shoot either on the first pull. The trigger goes all the way back and pushes the sear rod all the way back too!! Very weird situation. It seams as though the sear assembly is sticking or the on/off pin is not being pushed all the way out when it resets
What I've done: I've inspected and oiled all the orings. None of them seem to be worn at all. I took out the sear to make sure the solenoid wasnt bent and causing some friction. Everything seems to be in line.
This is a pain b/c I always have to pull the trigger a few times to make sure it will fire before I snap shoot or something
please any suggestions would be great