PDA

View Full Version : A warp with a Z-grip?



a_malfunction
08-27-2001, 09:18 PM
I may be getting both a z-grip and a warp, and just wanted to know what sort of problems, if any, that you (people who have done this) ran into when trying to set it up. Thanks for any input!

------------------
When in doubt, duck. When certain, don't bother, you're already screwed.

magc68
08-27-2001, 10:06 PM
u might want to move the warp plate back at an angel. just turn the warp plate and drill a new mounting hole for the screw to go into the frame. ill post a pic later...

------------------
Team Recursion's Website (http://recursionpb.homestead.com/index.html)

PyRo
08-28-2001, 04:16 PM
What? I'm confused http://www.automags.org/ubb/smile.gif With the Z i just stuck mine on, as close in as it could go, angled foward. Is their that much of a differance between the PTP and AGD bracket that you cannot get it in that posision, or am i just weird for having the warp like that http://www.automags.org/ubb/smile.gif

MajorDamage
08-28-2001, 04:55 PM
If you want to offset your tank to get the maximum performance for the tank you will have to make an offset plate. Just get a little peice of metal about three inches long and put two sets of bottomline holes in it. It'll make your warp go out about an inch more than usual if you move it in as far as it will go against your tank. If you want a picture of the offset plate email me at gameriggincarnie@hotmail.com and I'll send you a picture. Hope this helps.

ENDO!

------------------
GO HERE!: <A HREF="http://wsnonline.8k.com" TARGET=_blank>http://wsnonline.8k.com

</A>The Witherspoon News! Sign the guestbook! It better than sunglasses, and twice as fragrent!