ok, heres the deal

[AutomagN2]

Everyone knows about my gun pressure dropping to the 0 psi and stuff liek that on my previous post.

I took my valve off, i popped it out, un screwed it, and looked at the reg seat. The reg seat was worn signifigantly, i will replace it.

Another tough thing i have to ask is, when i screw my nitro tank in, as the gun pressureizes, it shoots once, is this normal? Whats causing it to do that?

[EsPo]

i have never expierienced(i suck at spelling) a gun shooting when it gasses up, that if quite odd. It is a good idea to hold the trigger when gassing up the gun.

[Gotcha3]

Hmmm, that is odd. Sounds like it is probably your sear (check to make sure that it is not worn) Also, check your on/off assembly.
Hope this helps,
Aaron

[Bulldog]

I have experienced that, on two seperate guns, and I have absoloutly no idea what causes it. :D :confused:

[AutomagN2]

I'm going to order a new reg seat since its worn all wierd.

[spazzed]

I'd recommend a new sear too.

[toymyster]

I have seen that happen on Retro Valves, just clean and oil your on/off real well!!

[AutomagN2]

On off valve on my tank? cause i don't have one, its screw in, pressurize and go. My tank output pressure is horrible, i have a regulator on my gun and i don't need it cause the gun has one itselft.

[Kevmaster]

he means the on-off pin on the mag. its the thing that the sear engages. when you pull the valve out, its got a little brass(on the RT, alum on the classic) head that pops out with a pin inside of it

[AutomagN2]

ooo so i could be like stuck? and then pop out. ok i'll slick it up.

[Kevmaster]

define "slick it up"

just make sure theres no gunk in there and put a drop of paintball oil on it....

[AutomagN2]

heh, i was just gonna put a drop on. Thanks everyone.