Warp feeding

[andrewnelles]

When i fire a single shot with my warp it feeds 1 one ball but spins like more should be feed, since the tube is ful lthe motor locks and bames a brief whining noise? Is this normal? How do i fix it?

[rikkter]

theres jumper settings on the board, 4 of them, if all 4 ofthem are in, it spins less when it gets told to spin, if no jumpers are in,it spins the longest when it gets told to spin.
try adding anohter jumper to it.

[krafty]

Also make sure your warp discs are properly oiled. If they're not slipping past the balls it will wear your motor.

[xen_100]

I have had my warp for about a year and a half. never oiled the disks. when the warp gets full the disks just stop and the motor slips on the drive belt. never had a problem with it.

[hitech]

You want the disks to slip past the paintballs. You don't want the belt to slip (that is a "fail safe"). You probably need to oil the disks. Also, make sure they are spaced correctly. With a paintball between the disk you do NOT want it to look like this:

[hitech]

But more like this:

[andrewnelles]

My spacing is off, how do i fix it? i just got a warp, dont know much about it.

[hitech]

Originally posted by andrewnelles
My spacing is off, how do i fix it? i just got a warp, dont know much about it.
Take the warp apart, remove the disk "pack", take it apart and use tape on the hub to space it out some. Or you could make a shim from thin cardboard (like a cereal box).