Low Pressure HPA Tank for my Automag

[DeathscytheSK]

Would it be good to get a tank with Low Pressure output of 450psi for my automag? I don't know much on what kind of output I should get for my automag but here is the link for the tank http://store.yahoo.com/actionvillage/031-7350-1.html

[Mossman]

Bad idea, get a preset at 800-850 range. You could only run a mag nicely with 400psi into it if u gutted the back 1/2 of the mag (the reg. half)....but a tank reg wouldnt be consistant enough to do nearly as good of a job as the mag valve does.

Long story short, get the HP screwin

[pbguy888]

nope low pressure prestets are not for mags. You need the high output pressure ones , that are around 800- 850 , around there.

[pbguy888]

beet me to it :( :p

[Scorch]

Originally posted by Mossman
You could only run a mag nicely with 400psi into it if u gutted the back 1/2 of the mag (the reg. half)....but a tank reg wouldnt be consistant enough to do nearly as good of a job as the mag valve does.

I'm not convinced that this. I believe a quality airsystem could easily drive the mag. Possibly with better consistency.

If a MacDev Conquest + Gladiator or MaxFlow can fuel a Shocker or Matrix which have significantly larger volume requirements, the mag should be no problem.

Scorch

[FESTUS33]

Mag's work best in the 750 to 900
range

[DeathscytheSK]

ok cool thanks, my second question is what is a good 68ci 4500psi tank for under 200? I am currently looking at this one http://store.yahoo.com/actionvillage/031-7300.html and this one http://store.yahoo.com/actionvillage/031-4010.html

[Dayspring]

Go with the Crossfire.