inline bleed valve????

[TheJester]

does any one know where i could find 1? w/ my x-valve, i'm not sure if it's the valve, or the lvl 10 bolt (prolly a mix of them both, i think it's more the bolt though) my gun retains alot of residual presure. i always shoot as much of the presure out as possible, but even still it makes my tank difficult to take off, and it's VERY hard to slide my quick dissconnect to come apart. so does any 1 know of an inline bleed that i could throw in to bleed the presure in the lines before i take my tank off?

[yeahthatsme]

a slide chekc bleeds off the pressure when you turn it off. or a pro connect.

[petefol]

pro connect would be the safest bet, and they also look better in my opinion. they will cost about 40$ tho.

[Cha0tic]

if you want to go top of the line, go get a pro connect

[FESTUS33]

That is a side effect of the level 10,
if you use a screw in tank just shoot
it down til it just click's then loosen
you're tank to bleed off the residual air.
It should'nt be enough to damage you're
O-ring. If you're not using a screw in
go with the Pro Connect.
Rick
:eek: