Schnitzel
01-17-2003, 09:24 PM
im planning on doing some major wiring for my emag/warp/revvy setup.
here's what i have so far:
emag battery (just waiting to be tapped;))
warp with interlink cable
12V revvy w/x-board
now i've read and re-read robAGD (http://www.robagd.com/revy-hack/)'s instructions, with some help from Toymyster. I want to know if i could have some help with some experienced AO'ers. i have an idea, and need to know if it works.
-power revvy and warp from emag battery, and also intelli-link my revvy.
i was going to do the warp mod as per robAGD's instructions with the voltage regulator and capacitors. i will run the power coming from the emag to the regulator, and split power to the warp and the revvy (again, following rob's instructions). and then i was going to also tap into my interlink cable to the revvy to intellifeed it.
so, is it impossible? ive attached a pic.
here's what i have so far:
emag battery (just waiting to be tapped;))
warp with interlink cable
12V revvy w/x-board
now i've read and re-read robAGD (http://www.robagd.com/revy-hack/)'s instructions, with some help from Toymyster. I want to know if i could have some help with some experienced AO'ers. i have an idea, and need to know if it works.
-power revvy and warp from emag battery, and also intelli-link my revvy.
i was going to do the warp mod as per robAGD's instructions with the voltage regulator and capacitors. i will run the power coming from the emag to the regulator, and split power to the warp and the revvy (again, following rob's instructions). and then i was going to also tap into my interlink cable to the revvy to intellifeed it.
so, is it impossible? ive attached a pic.