Magic37220
01-21-2003, 04:33 PM
I've got an intellifeed-ready C&C Ir3 and a warpfeed.
I saw the thing on automags.org that lets you make a wire connecting the board to the warpfeed, but im figuring that the "intellifeed-ready" ness of the ir3 should make it easier than cutting those wires. I also did a search and read about buying some kit and cutting something off, but I'm confused about that.
Can't I just buy a simple wire that goes from the port in my "intellifeed-ready" ir3 to the plug in the warp? and if not, is there any alternative to stripping wires in my board (thats what automags.org has you do), like something involving that intellifeed port on the ir3?
Thanks in advance
I saw the thing on automags.org that lets you make a wire connecting the board to the warpfeed, but im figuring that the "intellifeed-ready" ness of the ir3 should make it easier than cutting those wires. I also did a search and read about buying some kit and cutting something off, but I'm confused about that.
Can't I just buy a simple wire that goes from the port in my "intellifeed-ready" ir3 to the plug in the warp? and if not, is there any alternative to stripping wires in my board (thats what automags.org has you do), like something involving that intellifeed port on the ir3?
Thanks in advance