mircromag concerns

[thevilduk]

allrighty guys, i did a search and found not much but i was wondering if i was building a mag out of a powerfeed micro mag body, should there be any concerns? Like parts not fitting and the like.
I have a freak for it, plan on getting an intelliframe and an x valve.

Right now all i have is the body, with the vertical adaptor and barrel.

anything that is suggested or stated is highly appreciated.

thevilduk

[big E kingpin]

i have a powerfeed micro, have had it for quite some time now. love it, everthing you have listed should fit no prob

[ChucktheMAGician]

The X-valve will probably come w/ a sear but it sounds like you will still need a sear pin to go thru it.

[smilestyler]

On my micromag the trigger frame holds in the pin for the sear, But on my automag it has the rail holding it in. The automag trigger frame didn't hold the sear pin in place, and it would slide out of the micromag, but there are lots of ways to fix this problem. I filled the hole with silicone. I seen one person drill a hole and tap threads on the underside for a set screw.
Does anyone know if there is an intelliframe that is specifically made for micromag bodies?