How does the PTP Warp work?

[Snake847]

How does the PTP Warp work?????
I have it and i push a button it spins then stops.....
so confused. Someone please enlighten me! OR post a link.

[rikkter]

same way the original warp works
http://www.airgun.com/downloads/WarpInstructions.pdf

[kdawg]

Either use the intellifeed or the vibration sensor.
If using the vibe sensor, you need to adjust the sensor. It should spin when it feels vibration....tap on it to see if you can get it to spin that way.

[rikkter]

actually the PTP warp feed has a externl vibration sensor.
you plug this in the little female jack that is next to the white button, and tap on that instead of the unit

[Snake847]

I do and it dosn't shoot.

[Jonesie]

Originally posted by Snake847
I do and it dosn't shoot.

You need to adjust the sensitivity as per the instruction manual.

Jonesie

[riooso]

The PTP Warp that I have broke about a month out. The sensor was in the main plate that the warp bolts to and fell out. The plate was machined to receive that vibration sensor and it finally cracked. I had to make a new one which is no big deal but a pain.
I would personally get the AGD one and make it work.

R

[rikkter]

yeah i dont like the plate. i've intellied my warp but i still have to use the damn external vibration to mount it on my gun. i found it usuless as theres barely any screw holding DZ3, and warp bracket to the trigger frame.

[Jonesie]

Originally posted by rikkter
yeah i dont like the plate. i've intellied my warp but i still have to use the damn external vibration to mount it on my gun. i found it usuless as theres barely any screw holding DZ3, and warp bracket to the trigger frame.

Go to the hardware store and buy 2 #10-32 screws that are long enough - problem solved! :)

Jonesie