How is the efficiency on your Emag?

[drewstair]

Just wondering what the average Emag with level 10 gets on a 68/4500. Just got my micro today and want to make sure I am on par.

[PsychoBaller]

Well.. on my SFL Emag with LX.... on my 68/4500 Geddon... I get between 800-1100shots.

I have not actually played with it enough to narrow down those figures... but thats the range I have gotten so far...

~da baller

[56kSomeGuy]

Well my micro-e gets from my 88/45 about 1300-500 shots but i still that is kinda low compared to some cockers that could get a case of paint off an 88/45.

[FutureMagOwner]

enough for me to last the whole day with one fill(i normally have to get it filled in the begining because my tanks are always empty when i get there and then i only fill it one more time depending on how high they go)

[RamboPreacher]

it "blows". hehehehee :D (pun intended)

actually, I am used to a much more efficient system, as in my Blazer, but the Xmag (still haven't named her - and all my markers get named if I use them enough) will get well over 1000 in a 88/4.5. It is still new, so haven't tracked that close yet.

[dogEmedic]

Last time I played I got 900-1000 shots with just under 1000psi left in the tank, Setup was a lx emag and crossfire 68/4.5k

[Havoc_online]

average numbers on a RT/Emag valve with a tuned level 10 on a 4500psi tank.

45ci leads to around 800 shots
which is a revy and a little over 4 pods.

68ci should give you about 1,200 shots
that's a revy and a little over 7 pods. that's pretty darn good for a 68/4500. Most mid/front players dont take more than 7 pods out on the field.

back players do and back players dont use 68ci tanks. More like a 88ci or 114ci.

88ci leads to around 1550 shots
which is a revy and almost 9 pods.

114ci leads to around 2000 shots
which is a revy and almost 13 pods.

You should have a good paint/barrel match and a reasonable input pressure. Dont follow the dumb formula of 68* 10 on a 3000psi tank and *15 on a 4500psi tank, that does not apply to most markers. Your level 10 should be set once broken in, if it's not then something is wrong.

[stedyone]

I've got a 68/3000 AGD Flatline system and with L10 I get around 800-900 rounds on a ~2600-2800 lb fill. It's not that great! Everywhere I go I always here: "Great Emag, too bad it's a gas hog!"

[Kevmaster]

I would usually get 1100-1300 off a 4500psi fill on my PTP Emag LX. to put it in comparison: my rainmaker gets 1500 off that same tank...and if thers only ONE typical gas hog out there....its a rainny