i need measurements

[crazayman]

i have a friend whos a machinist and hes doin me a favor and making me a custom mag. we have 4 questions.

-how long is the outter valve body? (the part where it expands to go outside the gun, and the split with the reg, where it expands to the back of the reg, how long is that?)

-how far from the edge of the outter valve body is it to the centre of the feild strip pin? (where it expands to go outside of the gun mainbody, to the center of where the field strip pin goes in)

-how much travel does the bolt have? (lvl 10 if it makes a difference)

- what radius is the inside of the mainbody to fit the valve with a bolt?

-does the field strip pin come with the retro valve?



if we could get those answers, we would be very greatful, especially me. things all go right, it will be one heck of a kick butt gun.

Thanks, crazayman

[Kevmaster]

i would strongly suggest purchasing a Sluggo body! These bodies are raw aluminum ready and made to be milled to your desires. They are great little bodies and the bottom is already perfect to fit into the rail:
http://store.airgun.com/acb/showprod.cfm?&DID=17&CATID=23&ObjectGroup_ID=67

http://store.airgun.com/agdprod/images/slug_med2.jpg

[crazayman]

thats great, but we were gonna lathe it down as much as possible and carbon fiber wrap it. aint never seen no carbon fiber gun before, but, its gonna be killer.