Are the RT valve and Evalve the same?

[StygShore]

I have a ReTro valve in my Micromag, and I am going to be upgrading it to an E-Micro. Will the ReTro valve work the same at the E-valve, or do I have to make any kind of adjustments?

Thanks

[digitard]

The On/Off pins are different lengths in standard, rt and Emags .... but other than that they're the same valve. So you should just keep the Emag valve in the Emicro.

Sincerely,
Dave K

[athomas]

Check the on/off pin length of your retro valve. The e-micro requires the on/off pin to be .670 - .675 inches long to function properly. Now all you need is the Proteam emag sear assembly.

[EsPo]

Originally posted by digitard
The On/Off pins are different lengths in standard, rt and Emags .... but other than that they're the same valve. So you should just keep the Emag valve in the Emicro.

Sincerely,
Dave K

perfectly said :D

[sneakyhacker420]

retro on/off pin length: .750

emag on/off pin length: .712


emag on/off assembly also has a quad o-ring setup in the bottom instead of the two as usual in the retro... otherwise its the same as any other retro valve