View Full Version : ACE on Micromags
StygShore
02-12-2003, 09:06 AM
Will the ACE install be available for the Micromags?
When, how much, how long will it take and stuff like that....
Thanks
Styg
no, there is no way it could be
StygShore
02-12-2003, 08:00 PM
Why isn't there a way the ACE could be installed in the E-Micromag? I am not sure what the actual design of the ACE is, but couldn't it be installed into the E-Micro from the bottom of the body, maybe by tapping a hole, and having a threaded housing for the ace, and a nylock set screw to hold it in place and keep it from moving?
Chris
speedyejl
02-12-2003, 08:15 PM
the E is ahh... key there
There isnt a drop in kit or anything but it could be done.
It would be eaiser to buy an X mag or just the body and frame with board and ace.
Otherwise you would have to probably make your own ace board then hook it up to the E micros board, then reprogram the board. Not to mention the milling to get an eye in the body rail, tapping a hole in the bod, etc.
StygShore
02-12-2003, 08:21 PM
Is the ACE a separate entity than the normal board for an Emag or X-Mag? I thought they were controlled from the same board. Wont the X-Mag board fit into the grip frame of the Micro-E?
Anyone have pics of the ACE out of a gun?, I guess that would maybe help me understand why it would not work.
Chris
mxracer33x
02-13-2003, 05:30 PM
I believe it would be very possible. I can see the easiest way would be to get a ULE Grip frame used on the X-mags, and the ACE board. The frame is already milled for the ACE board. Then you would have mill the spacer plate and Micromag body for the Eye. It would make a nice project.
And yes the ACE board is a seperate board. It sits on top of the grip frame, and covers up most of the slot/hole up front where the power wires run through the frame. I can take pics later on tonite and post if you like.
Good luck
StygShore
02-13-2003, 06:25 PM
Yes please post some pics of the ACE install, I have a guy milling my Micromag body right now. If I can get some dimensions or ideas, I can have him work on the grip frame and body to allow for the ACE install.
I think it has a standard Emag grip, not the ULE - I have not gotten the frame or battery pack yet, hopefully be in my door tonight. I might be able to mill the standard grip to take the ACE board, or find a way to incorporate it into the spacer or battery pack area.
Styg
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.